Menu
DP-5000

DP 5000 Amplifier

Compare
Categories: ,

Product Description

 

Model DP5000
Number of channels 4
Peak total output all channels driven 10000 W

 

Peak output voltage per channel 150 V

 

Max. output current per channel 38 Arms

 

Max. Output Power

 

            16 ohms per ch. (all ch.’s driven) 660 W

 

8 ohms per ch. (all ch.’s driven) 1300 W
4 ohms per ch. (all ch.’s driven)             2100 W
2 ohms per ch. (all ch.’s driven)             2500 W
16 ohms Bridged per ch. 2600 W
8 ohms Bridged per ch. 4200 W
4 ohms Bridged per ch. 5000 W
2 ohms Bridged per ch. Note 3)
Performance with Gain 35 dB and OVP: 150 V
THD 20 Hz – 20 kHz for 1 W <0.1%
THD at 1 kHz and 1 dB below clipping <0.1%
Signal To Noise Ratio >112 dBA
Channel separation (Crosstalk) at 1 kHz >70 dB
Frequency response (1 W into 8 ohms) +0/-3 dB 6.8 Hz – 30 kHz
Input Impedance 20 kOhm
Input Common Mode Rejection, CMR 45 dB
Output impedance @ 100 Hz 56 mOhm
Output slew rate into 8 ohms 20 V/microsecond
Connectors and switches
Input connectors (per ch.) 3-pin XLR, electronically balanced
            Output bridge mode per two ch.’s A+B – Ch. A is signal input source
A+B, C+D – Ch.’s A and C are
input source
Intelligent fans (on/off) Yes, depending on presence of output signal
            Power on/off and Remote enable on/off Individual switches on front-panel
            Cooling Four fans, front-to-rear airflow,
temperature controlled speed
Power
Operating voltage, PFC 85V ~ 265 V
Power Average Limiter (PAL)2) Yes
Soft start / Inrush Current Draw Yes / max. 5 A
Mains connector 230 V CE: 16 A, CEE7;
115 V ETL: 30 A Twist lock
Dimensions (WxDxH) Unit(mm) 483 x 503 x 89
Packing(mm) 580 x 560 x 165
Weight(kg) 16kg
Net weight 19kg
            Finish Black painted steel chassis with black
painted steel / aluminum front

 

 

Note 1): Automatic -6 dB gain compensation when bridging channels.

Note 2): PAL can reduce the maximum output power to keep the power supply operating safely, and/or to prevent excessive current draw tripping the mains breaker. Refer to Operation Manual.

Note 3): The amplifier will be fully operational at bridge-mode 2 ohm loads, but due to physical constraints in the construction, the max. output power will not be significantly higher than running individual channels and therefore not stated here.

Note 4): Separate 230 V or 115 V versions available. Not selectable on the amplifier. All specifications are subject to change without notice.

Reviews

There are no reviews yet.

Be the first to review “DP 5000 Amplifier”

  TOP